Home › Vehicle Exterior › WINDOW / GLASS › POWER WINDOW CONTROL SYSTEM
RM27L0U _59 Vehicle Exterior _049347 WINDOW / GLASS _0235939 POWER WINDOW CONTROL SYSTEM J

WINDOW / GLASS  POWER WINDOW CONTROL SYSTEM  All Power Windows does not Operate with Door Key Cylinder  


DESCRIPTION

When the driver door key cylinder (key linked switch) is turned, the following occurs: 1) the door lock motor receives the signal; 2) the main body ECU sends the signal to the power window regulator motor; and 3) the power window motors are activated.

WIRING DIAGRAM

B212869E01
0.469,4.831 1.482,5.002 1.013,0.171 10 Main Body ECU 1.015,5.195 2.653,5.366 1.638,0.171 10 LIN Communication Line 2.665,4.803 4.537,4.980 1.873,0.177 10 Front Door Lock Assembly LH 2.466,2.665 4.463,3.002 1.997,0.337 10 Front Power Window Regulator Motor Assembly RH 4.754,1.061 6.115,1.583 1.361,0.522 10 Front Power Window Regulator Motor Assembly LH 2.427,1.07 4.424,1.407 1.997,0.337 10 Front Power Window Regulator Master Switch Assembly 1.883,3.815 2.104,3.986 0.220,0.171 10 DD 1.899,3.579 2.084,3.729 0.186,0.151 10 53 1.462,4.387 1.672,4.547 0.210,0.161 10 H4 1.463,4.181 1.643,4.322 0.181,0.141 10 10 2.783,3.713 2.894,3.879 0.111,0.166 10 9 2.724,4.283 2.910,4.429 0.186,0.146 10 10 2.605,4.63 2.833,4.776 0.228,0.146 10 M4 4.506,3.987 4.632,4.153 0.126,0.166 10 7 3.001,3.812 3.137,3.988 0.136,0.176 10 L 3,4.408 3.218,4.572 0.218,0.163 10 UL 4.236,4.107 4.372,4.263 0.136,0.156 10 E 2.466,2.474 2.691,2.635 0.225,0.161 10 L3 3.136,2.142 3.396,2.311 0.260,0.169 10 LIN 2.948,1.991 3.047,2.157 0.099,0.166 10 9 3.1,0.486 3.427,0.630 0.326,0.144 10 LIN1 4.074,0.486 4.403,0.642 0.330,0.156 10 LIN2 2.427,0.9 2.677,1.056 0.250,0.156 10 M2 5.669,0.479 5.945,0.641 0.275,0.161 10 LIN 5.45,0.33 5.571,0.481 0.121,0.151 10 9 4.479,0.332 4.590,0.488 0.111,0.156 10 7 2.888,0.317 3.019,0.473 0.131,0.156 10 6 1.476,0.274 1.649,0.430 0.173,0.156 10 10 1.476,0.512 1.755,0.668 0.278,0.156 10 H2 1.147,3.825 1.336,3.978 0.189,0.152 10 L2 1.432,3.726 1.632,3.877 0.201,0.151 10 10 1.054,4.399 1.344,4.560 0.290,0.161 10 UL3 0.999,0.482 1.338,0.653 0.339,0.171 10 LIN2 4.769,0.875 4.980,1.036 0.210,0.161 10 M3

PROCEDURE

1.CHECK LIN COMMUNICATION SYSTEM
a.

Check for LIN communication system DTCs related to the power window control system.

OK:

LIN communication system DTCs are not output.




OK

2.CHECK DTC (B2312)

NG

2.CHECK DTC (B2312)
a.

Check if DTC B2312 is output (See page Vehicle Exterior>WINDOW / GLASS>POWER WINDOW CONTROL SYSTEM>DTC CHECK / CLEAR).

OK:

DTC B2312 is not output.




OK

3.READ VALUE USING TECHSTREAM (DOOR LOCK SWITCH)

NG

3.READ VALUE USING TECHSTREAM (DOOR LOCK SWITCH)
a.

Connect the Techstream to the DLC3.


b.

Turn the ignition switch to ON.


c.

Turn the Techstream on.


d.

Enter the following menus: Body Electrical / Main Body / Data List.


e.

According to the display on the Techstream, read the Data List.

Main Body
Tester Display Measurement Item/Range Normal Condition Diagnostic Note
Door Key SW-Lock Door key linked lock switch signal / ON or OFF ON: Driver side door key cylinder turned to lock position
OFF: Driver side door key cylinder not turned
-
D Door Key SW-UL Door key linked unlock switch signal / ON or OFF ON: Driver side door key cylinder turned to unlock position
OFF: Driver side door key cylinder not turned
-

OK:

On the Techstream screen, each item changes between ON and OFF according to above chart.




OK

4.CHECK POWER WINDOW MANUAL FUNCTION

NG

4.CHECK POWER WINDOW MANUAL FUNCTION
a.

Check that the manual UP/DOWN function using the power window regulator switch can operate the front door power window LH and RH (See page Vehicle Exterior>WINDOW / GLASS>POWER WINDOW CONTROL SYSTEM>OPERATION CHECK).



OK

REPLACE MAIN BODY ECU

NG

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE