Home › Vehicle Exterior › WINDOW / GLASS › BACK DOOR POWER WINDOW MOTOR
RM27L0U _59 Vehicle Exterior _049347 WINDOW / GLASS _0235947 BACK DOOR POWER WINDOW MOTOR A

WINDOW / GLASS  BACK DOOR POWER WINDOW MOTOR  INSTALLATION  


PROCEDURE

Hide 85710G 1.INSTALL POWER WINDOW REGULATOR MOTOR ASSEMBLY RH

HINT:
·

To prevent the drum and cable from coming off, do not tilt the drum, subject it to shocks or use force on it.

·

If the cable comes off the drum, do not rewind the cable and do not reuse it.

·

After installing the window regulator, do not operate it by itself, because some types of regulator do not have a stopper.



a.
B062867E02
1.844,0.75 1.76,0.26 1.76,0.26 1.698,0.26 false 0.792,0.146 1.542,0.323 0.75,0.177 10 false MP Grease

Apply MP grease to the as shown in the illustration.


b.
B062868

With the holding tool installed, match the holding tool with the motor housing.


c.
B062869

Push down on the wire guide and drum, and insert the drum into the motor housing.

NOTICE:

If you can not insert the drum into the motor, slowly slide the bracket for installing the glass, and insert the drum while aligning the drive shaft of the motor with the drum.



d.
B062870

Install the power window regulator base plate with the 2 screws.


e.

Install the power window regulator motor onto the back door power window regulator.


Hide 69850D 2.INSTALL BACK DOOR POWER WINDOW REGULATOR ASSEMBLY

Hide 68131 3.INSTALL BACK DOOR GLASS

Hide 68275 4.INSTALL BACK DOOR GLASS RUN

Hide 68290A 5.INSTALL BACK DOOR GLASS OUTER WEATHERSTRIP ASSEMBLY

Hide 75816 6.INSTALL BACK DOOR OUTSIDE MOULDING LH

a.
B191708

Engage the 5 clips and install the new back door outside moulding.


Hide 75815 7.INSTALL BACK DOOR OUTSIDE MOULDING RH

HINT:

Use the same procedure as for the LH side.


Hide 85293A 8.INSTALL REAR WIPER STOPPER

Hide 85143R 9.INSTALL REAR WIPER MOTOR GROMMET

Hide 85110R 10.INSTALL REAR WIPER MOTOR ASSEMBLY

Hide 85220R 11.INSTALL REAR WIPER BLADE ASSEMBLY

Hide 85292A 12.INSTALL REAR WIPER ARM HEAD CAP

Hide 67848C 13.INSTALL NO. 2 BACK DOOR SERVICE HOLE COVER

Hide 89221 14.INSTALL MULTIPLEX NETWORK BODY ECU (w/ Power Back Door)

Hide 67847A 15.INSTALL BACK DOOR SERVICE HOLE COVER

Hide 67750 16.INSTALL BACK DOOR TRIM BOARD ASSEMBLY

Hide 67961 17.INSTALL BACK DOOR PULL STRAP

Hide 67963A 18.INSTALL BACK DOOR STRAP COVER

Hide 67938A 19.INSTALL BACK DOOR SIDE GARNISH LH

Hide 67937B 20.INSTALL BACK DOOR SIDE GARNISH RH

Hide 67939B 21.INSTALL BACK DOOR CENTER GARNISH