When the sliding roof drive gear (sliding roof ECU) detects malfunctions in the motor, and the sliding roof operation is stopped, DTC B2341 is stored.
When the sliding roof drive gear (sliding roof ECU) detects malfunctions in the gear, and the sliding roof operation is stopped, DTC B2344 is stored.
| DTC Code | DTC Detection Condition | Trouble Area |
|---|---|---|
| B2341 | Sensor (Motor) Failure | Sliding roof drive gear (Sliding roof ECU) |
| B2344 | Position Failure | Sliding roof drive gear (Sliding roof ECU) |
Clear the DTCs (See page Vehicle Exterior>SLIDING ROOF / CONVERTIBLE>SLIDING ROOF SYSTEM>DTC CHECK / CLEAR).
Check for DTCs (See page Vehicle Exterior>SLIDING ROOF / CONVERTIBLE>SLIDING ROOF SYSTEM>DTC CHECK / CLEAR).
| Result | Proceed to |
|---|---|
| DTC B2341 or B2344 is output | A |
| DTC B2343 is output | B |
| No DTC is output | C |
A
B
C
(See pageGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING)
Connect the Techstream to the DLC3.
Turn the ignition switch to ON.
Turn the Techstream ON.
Enter the following menus: Body Electrical / Sliding Roof / Data List.
According to the display on the Techstream, read the Data List.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
|---|---|---|---|
| Hall IC1 Pulse | Sliding roof operation signal/LO or HI | LO: Sliding roof motor is not operating
HI: Sliding roof motor is operating |
- |
| Hall IC1 Status | Sliding roof operation signal/NORMAL or LOCK | NORMAL: Sliding roof motor is operating
LOCK: Sliding roof motor is not operating |
- |
| Hall IC2 Pulse | Sliding roof operation signal/LO or HI | LO: Sliding roof motor is not operating
HI: Sliding roof motor is operating |
- |
| Hall IC2 Status | Sliding roof operation signal/NORMAL or LOCK | NORMAL: Sliding roof motor is operating
LOCK: Sliding roof motor is not operating |
- |
The Techstream displays as shown in the table according to the sliding roof motor operation.
OK
(See pageGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING)
NG