75924C
1.INSTALL NO. 2 BLACK OUT TAPE
Application precautions (See page Vehicle Exterior>EXTERIOR PANELS / TRIM>BLACK OUT TAPE(for Front Door)>INSTALLATION).
Clean the attachment surface (using an infrared light) (See page Vehicle Exterior>EXTERIOR PANELS / TRIM>BLACK OUT TAPE(for Front Door)>INSTALLATION).
Clean the attachment surface (using a tape removal disc) (See page Vehicle Exterior>EXTERIOR PANELS / TRIM>BLACK OUT TAPE(for Front Door)>INSTALLATION).
Apply new No. 2 black out tape to the positions shown in the illustration.
| Mark | Measurement |
|---|---|
| a | 2.0 mm (0.079 in.) |
| b | 3.0 mm (0.118 in.) |
| c | 1.0 or less (0.039 or less in.) |
68152C
2.INSTALL REAR DOOR GLASS RUN
Use the same procedure as for the RH side (See page Vehicle Exterior>DOOR / HATCH>REAR DOOR>REASSEMBLY).
67604
3.INSTALL REAR DOOR TRIM BOARD SUB-ASSEMBLY
Use the same procedure as for the RH side (See page Vehicle Exterior>DOOR / HATCH>REAR DOOR>REASSEMBLY).
74272A
4.INSTALL REAR DOOR ARMREST BASE UPPER PANEL
Use the same procedure as for the RH side (See page Vehicle Exterior>DOOR / HATCH>REAR DOOR>REASSEMBLY).
69284D
5.INSTALL REAR DOOR INSIDE HANDLE BEZEL PLUG
Use the same procedure as for the RH side (See page Vehicle Exterior>DOOR / HATCH>REAR DOOR>REASSEMBLY).
67674A
6.INSTALL REAR DOOR FRAME GARNISH
Use the same procedure as for the RH side (See page Vehicle Exterior>DOOR / HATCH>REAR DOOR>REASSEMBLY).
68164A
7.INSTALL REAR DOOR GLASS OUTER WEATHERSTRIP
75766A
8.INSTALL REAR DOOR WINDOW FRAME REAR MOULDING