PRECAUTIONS FOR BLIND SPOT MONITOR SYSTEM
The blind spot monitor system may not detect vehicles in the detection areas in the following conditions:
During bad weather such as heavy rain, fog, snow, or a sandstorm.
When there is a significant difference in speed between this vehicle and vehicles that enter the detection area.
When another vehicle in a detection area starts off at the same time as this vehicle, and the other vehicle remains in the detection area when the speed of this vehicle reaches the detection start speed.
When a vehicle enters the detection area when driving on a steep hill.
When this vehicle is pulling a trailer.
When a vehicle in an adjacent lane attempts to merge while traveling at approximately the same speed.
In this section, the expression "this vehicle" is used to refer to the vehicle equipped with this blind spot monitor system.
The blind spot monitor system is not designed to detect the following types of vehicles or objects:
Oncoming vehicles.
Small motorcycles, bicycles, pedestrians, etc.
Following vehicles that are in the same lane.
Guardrails, walls, signs, parked vehicles and similar stationary objects.
Vehicles driving 2 lanes away from this vehicle.
The blind spot monitor system may detect a vehicle or object unnecessarily in the following conditions:
When guardrails, walls, signs, parked vehicles or similar stationary objects enter the detection area.
When vehicle lanes are narrow and a vehicle driving 2 lanes away from this vehicle enters the detection area.
When driving around a sharp bend and a following vehicle is present.
NOTES FOR BLIND SPOT SENSOR
One blind spot monitor sensor is installed inside the left and right sides of the vehicle rear bumper respectively. Observe the following to ensure the blind spot monitor functions correctly.
Keep the sensors and surrounding areas clean at all times.
Do not subject a sensor or surrounding area to a strong impact. If the sensor moves even slightly out of position, the system may malfunction and vehicles that enter the detection area may not be detected.
Do not disassemble the sensor.
Do not attach stickers, etc. to the sensor or the surrounding area.
Do not modify the sensor.
Do not paint the rear bumper any color other than an official Toyota color.
Do not apply strong impacts to the sensor or drop it, as it is a high-precision device.
Do not reuse a sensor that has been dropped or subjected to a strong impact.
If the bumper is damaged or the vehicle has a history of body repair, there is a possibility that the installation area of the blind spot monitor sensor may be deformed and the blind spot monitor sensor system may not operate correctly, so visually inspect the blind spot monitor sensor installation area (frame, stud bolt) to make sure it is not dented or bent.
Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>BLIND SPOT MONITOR SYSTEM>OPERATION CHECK
If the visual inspection finds a problem, check the installation condition of the blind spot monitor sensor, and adjust the installation position of the blind spot monitor sensor as necessary.