Home › SUSPENSION & AXLE › TIRE AND WHEEL › TIRE PRESSURE WARNING SYSTEM

TIRE PRESSURE WARNING SYSTEM > Tire Pressure Warning Reset Switch Circuit

for Preparation Click here


DESCRIPTION

The tire pressure warning ECU enters the initialization mode and performs initialization automatically. Then it receives the signal from the tire pressure warning reset switch. If the ECU receives the signal, the tire pressure warning light blinks 3 times (1 second on, 1 second off).

WIRING DIAGRAM


C140098E36


INSPECTION PROCEDURE

NOTICE:
  1. When replacing the tire pressure warning ECU, read the transmitter IDs stored in the old ECU using Techstream and note down before removal.
  2. It is necessary to perform initialization (Click here) after registration (Click here) of the transmitter IDs into the tire pressure warning ECU, after the ECU and/or tire pressure warning valve and transmitter has been replaced.

1.CHECK TIRE PRESSURE WARNING RESET SWITCH FUNCTION
  1. Perform the tire pressure warning reset switch test in TEST MODE PROCEDURE (Click here).

    OK:

    Switch Condition
    Specified Condition
    Tire pressure warning reset switch ON
    Tire pressure warning light turns on.
    Tire pressure warning reset switch OFF
    Tire pressure warning light blinks.

    Result 
    Result
    Proceed to
    NG
    A
    OK
    B



B
END
A


2.INSPECT TIRE PRESSURE WARNING RESET SWITCH


    C158396E01
  1. Remove the tire pressure warning reset switch (Click here).

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    1 - 2
    ON (Switch is pressed and held)
    Below 1 Ω
    OFF (Switch is not pressed)
    10 kΩ or higher



NG
REPLACE TIRE PRESSURE WARNING RESET SWITCH (Click here)
OK


3.CHECK HARNESS AND CONNECTOR (RESET SWITCH - ECU AND BODY GROUND)
  1. Disconnect the T4 reset switch connector.

  1. Disconnect the T15 ECU connector.



    E136996E15
  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    T15-1 (CLSW) - T4-1
    Always
    Below 1 Ω
    T15-1 (CLSW) - Body ground
    Always
    10 kΩ or higher
    T4-2 - Body ground
    Always
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE TIRE PRESSURE WARNING ECU (Click here)