Home › BRAKE › BRAKE CONTROL › VEHICLE STABILITY CONTROL SYSTEM

VEHICLE STABILITY CONTROL SYSTEM > Slip Indicator Light does not Come ON

for Preparation Click here


DESCRIPTION

The skid control ECU is connected to the combination meter via CAN and multiplex communications.
The SLIP indicator blinks during VSC and/or TRAC operation.
When the system fails, the SLIP indicator comes on to warn the driver.

WIRING DIAGRAM

Refer to Slip Indicator Light Remains ON .

INSPECTION PROCEDURE

NOTICE:
When replacing the brake actuator assembly, perform zero point calibration (Click here).

1.CHECK CAN COMMUNICATION SYSTEM
  1. Check if the CAN communication system DTC is output (Click here).

    Result:

    Result
    Proceed to
    CAN communication system DTC is not output
    A
    CAN communication system DTC is output
    B



B
INSPECT CAN COMMUNICATION SYSTEM
A


2.CHECK MULTIPLEX COMMUNICATION SYSTEM
  1. Check if the multiplex communication system DTC is output (Click here).

    Result:

    Result
    Proceed to
    Multiplex communication system DTC is not output
    A
    Multiplex communication system DTC is output
    B



B
INSPECT MULTIPLEX COMMUNICATION SYSTEM
A


3.CHECK SLIP INDICATOR LIGHT
  1. Connect Techstream to the DLC3.

  1. Start the engine.

  1. Select the Active Test mode on Techstream (Click here).

    ABS / VSC / TRAC: 
    Tester Display
    Test Part
    Control Range
    Diagnostic Note
    Slip Indicator Light
    SLIP indicator light
    Indicator light ON / OFF
    Observe combination meter

  1. Check that "ON" and "OFF" of the SLIP indicator light are indicated on the combination meter when using Techstream.

    OK:
    The SLIP indicator light turns on or off in accordance with Techstream.

    HINT:
    If troubleshooting has been carried out according to the Problem Symptoms Table, refer back to the table and proceed to the next step before replacing the part (Click here).



NG
Go to step 4
OK

REPLACE BRAKE ACTUATOR ASSEMBLY 

4.INSPECT COMBINATION METER ASSEMBLY
  1. Turn the ignition switch off.

  1. Perform Active Test of the combination meter (meter CPU) using Techstream (Click here).

    OK:
    The SLIP indicator light turns on or off in accordance with Techstream.

    HINT:
    If troubleshooting has been carried out according to the Problem Symptoms Table, refer back to the table and proceed to the next step (Click here).



NG
REPLACE COMBINATION METER ASSEMBLY
OK

REPLACE BRAKE ACTUATOR ASSEMBLY