Home › RESTRAINTS › SUPPLEMENTAL RESTRAINT SYSTEM › OCCUPANT CLASSIFICATION SYSTEM

DTC    B1795    Occupant Classification ECU Malfunction

for Preparation Click here


DESCRIPTION

DTC B1795 is recorded when a malfunction is detected in the occupant classification ECU.
Troubleshoot DTC B1771 first when the DTCs B1771 and B1795 are output simultaneously.

DTC No.
DTC Detecting Condition
Trouble Area
B1795
  1. Occupant classification ECU circuit malfunction
  2. The occupant classification ECU receives a short circuit to ground signal in the passenger side buckle switch circuit for 2 seconds.
  3. Occupant classification ECU malfunction
  1. Front seat wire RH
  2. Front seat inner belt assembly RH (Passenger side buckle switch)
  3. Occupant classification ECU

WIRING DIAGRAM

Click here.

INSPECTION PROCEDURE

1.CHECK DTC
  1. Turn the ignition switch to the ON position, and wait for at least 10 seconds.

  1. Check the DTCs (Click here).

    Result:
    A:
    DTC B1795 is output.
    B:
    DTCs B1771 and B1795 are output.

    HINT:
    Codes other than DTC B1771 and B1795 may be output at this time, but they are not related to this check.



B
GO TO DTC B1771
A


2.REPLACE OCCUPANT CLASSIFICATION ECU
  1. Turn the ignition switch to the LOCK position.

  1. Disconnect the negative (-) terminal cable from the battery, and wait for at least 90 seconds.

  1. Replace the occupant classification ECU (Click here).


NEXT


3.PERFORM ZERO POINT CALIBRATION
  1. Connect the negative (-) terminal cable to the battery.

  1. Connect the Techstream to the DLC3.

  1. Turn the ignition switch to the ON position.

  1. Using the Techstream, perform "Zero point calibration" (Click here).

    OK:
    "Zero Point Calibration is complete." is displayed.


NEXT


4.PERFORM SENSITIVITY CHECK
  1. Using the Techstream, perform "Sensitivity check" (Click here).

    Standard value:
    27 to 33 kg (59.52 to 72.75 lb)


NEXT

END