FRONT SEAT OUTER BELT ASSEMBLY > INSTALLATION |
| 1. INSTALL FRONT SHOULDER BELT ANCHOR ADJUSTER ASSEMBLY |
Install the front shoulder belt anchor adjuster assembly with the bolt.
| 2. INSTALL CENTER PILLAR UPPER GARNISH |
| 3. INSTALL FRONT SEAT OUTER BELT ASSEMBLY |
![]() |
Check the degree of tilt when beginning to lock the ELR.
Check that the belt does not lock within 15 degrees of tilt in all directions but that the belt locks with over 45 degrees of tilt, when gently moving the retractor.
If operation is not as specified, replace the front seat outer belt assembly.
Install the retractor with the 2 bolts.
Install the shoulder anchor with the nut.
Install the floor anchor with the bolt.
Install the floor anchor cover.
Check the ELR lock.
Check that the belt locks when pulling out the belt quickly when the belt is installed.
If operation is not as specified, replace the front seat outer belt assembly.
Check the fastening function of the child restraint system.
Check that the belt cannot be pulled out any more but can be rewound after the belt is fully pulled out.
Check that the belt can be pulled out and rewound after the belt is fully rewound.
If operation is not as specified, replace the front seat outer belt assembly.
| 4. INSTALL CENTER PILLAR LOWER GARNISH |
| 5. INSTALL FRONT DOOR WEATHERSTRIP |
| 6. INSTALL REAR DOOR WEATHERSTRIP |
| 7. INSTALL FRONT DOOR SCUFF PLATE |
| 8. INSTALL REAR DOOR SCUFF PLATE |
| 9. INSTALL FRONT SEAT ASSEMBLY |
| 10. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |
| 11. PERFORM INITIALIZATION |