64330D
1.REMOVE PACKAGE TRAY TRIM PANEL ASSEMBLY
67751
2.REMOVE BACK DOOR TRIM BOARD
81570
3.REMOVE CENTER STOP LIGHT ASSEMBLY
4.REMOVE NO. 1 AMPLIFIER ANTENNA ASSEMBLY
68131
5.REMOVE BACK DOOR GLASS
Disconnect the connector (1).
Perform the operations on the left and right side.
Remove T25 screw (2).
Perform the operations on the left and right side.
Apply protective tape to the outer surface of the vehicle body to prevent scratches.
| *1 | Back Door Glass |
| *a | Windshield Knife |
| *b | Adhesive |
|
Pull |
Apply soapy water to the adhesive area.
Insert the windshield knife into the adhesive.
Using a windshield knife, pull the blade of the windshield knife parallel to the back door glass surface and edge while holding the blade edge vertically and the back door glass edge.
Never pry the windshield knife.
Start from a place where the distance between the back door glass and the body is wide.
Cut the adhesive.
Using suction cups, remove back door glass (1).
64818B
6.REMOVE NO. 1 WINDSHIELD GLASS SPACER
Remove all No. 1 windshield glass spacers (1).
62785F
7.REMOVE BACK DOOR GLASS SPACER
Remove the all back door glass spacers.
8.REMOVE BACK DOOR SEAL
Remove the back door seal.
Perform the operations on the left and right side.