Home › General › MAINTENANCE › REAR BRAKE FLEXIBLE HOSE
RM3650E _V1 General _079881 MAINTENANCE _0387576 REAR BRAKE FLEXIBLE HOSE A

MAINTENANCE  REAR BRAKE FLEXIBLE HOSE  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH side and LH side.

·

The following procedure is for the LH side.



PROCEDURE

Hide 1.INSTALL REAR BRAKE HOSE

a.
C420442C01
1.563,3.083 1.875,3.281 0.313,0.198 10 false *a
*a Torque Wrench Fulcrum Length


Using a 14 mm union nut wrench, tighten the rear flexible hose (1) on the rear disc brake cylinder assembly.

Torque:
Specified tightening torque : 22 N*m (224 kgf*cm, 16 ft.*lbf)

HINT:
·

Calculate the torque wrench reading when changing the fulcrum length of the torque wrench.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION

·

When using a special tool (fulcrum length of 25.0 mm (0.984 in.)) + torque wrench (fulcrum length of 162 mm (6.38 in.)): 19.1 N*m (195 kgf*cm, 14 ft.*lbf)




b.

Insert the rear flexible hose into the holder (2).

NOTICE:

Make sure that the rear flexible hose does not rest against the components fixed to the body and that it is not twisted.



c.
C415176C02
3.052,0.896 3.292,1.104 0.24,0.208 10 false *a
*a Torque Wrench Fulcrum Length


Position and tighten the 11 mm union nut (1). If necessary, use the square end (2) for counter support.

SST
09700-WA070  

Torque:
Specified tightening torque : 17 N*m (173 kgf*cm, 13 ft.*lbf)

HINT:

Calculate the torque wrench readingwhen changing the fulcrum length of the torque wrench.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION



Hide 4.INSTALL REAR WHEEL