Use the same procedure for LHD and RHD vehicles.
The procedure listed below is for the LHD vehicles.
84306
1.INSTALL SPIRAL CABLE SUB-ASSEMBLY
84310
2.INSTALL TURN SIGNAL SWITCH ASSEMBLY
Connect the connectors (1) with the turn signal switch assembly (2).
Connect the turn signal switch assembly (2).
Using a deep socket wrench 7 mm, tighten the screws (1) to install the turn signal switch assembly (2) with the spiral cable sub-assembly.
45287
3.INSTALL LOWER STEERING COLUMN COVER
45286B
4.INSTALL UPPER STEERING COLUMN COVER
45100
5.INSTALL STEERING WHEEL ASSEMBLY
6.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
for B48:
for B58: