Wear protective gloves. Sharp areas on the parts may injure your hands.
Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
Child restraint seat anchor bracket is installed to the front passenger side.
73706A
1.INSTALL CHILD RESTRAINT SEAT ANCHOR BRACKET
Position the child restraint seat anchor bracket (2).
Replace the rivets (1).
Using an air riveter or hand riveter, attach the child restraint seat anchor bracket (2) with new rivets (1).
| *1 | Mandrel |
| *a | Riveter |
| *b | Incorrect |
| *c | Correct |
Do not pry on the rivets with the riveter, as this will cause damage to the riveter and mandrel.
| *a | Riveter |
| *b | Incorrect |
| *c | Correct |
Confirm that the rivets are seated properly against the child restraint seat anchor bracket.
Do not tilt the riveter when installing the child restraint seat anchor bracket with the rivet.
Do not leave any space between the rivet heads and child restraint seat anchor bracket.
| *a | Riveter |
| *b | Incorrect |
| *c | Correct |
Do not leave any space between the child restraint seat anchor bracket and front seat assembly. Firmly hold the child restraint seat anchor bracket and front seat assembly together while installing the rivet.
If the mandrel of the rivet does not come off on the first operation of the rivet gun, slide the rivet gun forward on the mandrel and operate it again.
Use the same procedure for the opposite side.
71811D
2.INSTALL FRONT SEAT CUSHION SHIELD (for Manual Seat)
Use the same procedure as for the driver side.
Click hereVehicle Interior>SEAT>FRONT SEAT CUSHION HEATER (for Manual Seat)>INSTALLATION
71811D
3.INSTALL FRONT SEAT CUSHION SHIELD (for Power Seat)
Use the same procedure as for the driver side.
Click hereVehicle Interior>SEAT>FRONT SEAT ASSEMBLY (for Power Seat)>REASSEMBLY
71861
4.INSTALL FRONT SEAT CUSHION INNER SHIELD (for Power Seat)
Use the same procedure as for the driver side.
Click hereVehicle Interior>SEAT>FRONT SEAT ASSEMBLY (for Manual Seat)>REASSEMBLY
5.INSTALL FRONT SEAT ASSEMBLY (for Power Seat)
Use the same procedure as for the driver side.
Click hereVehicle Interior>SEAT>FRONT SEAT ASSEMBLY (for Power Seat)>INSTALLATION