Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
73920A
1.INSTALL FRONT SEAT AIRBAG ASSEMBLY
Install the front seat airbag assembly (1) carefully into the pocket of the separate type front seatback cover (3).
Make sure that the stud bolts (4) do not damage the pocket in the cover.
Position the front seat airbag assembly (1) correctly in the separate type front seatback pad (2).
Position the separate type front seatback cover with pad (2) correctly.
Replace the nuts (1).
Tighten the nuts (1).
Position the separate type front seatback cover (1) correctly in the marked area and clip it in.
Using a special tool 0 490 472 (00 5 020), close the fasteners (1) in the marked area.
Position the separate type front seatback cover (1) correctly in the marked area and clip it in.
Attach the clamps (2).
Attach the separate type front seat cushion cover (1).
Install the connector to the connector housing.
Attach the claws to install the connector (1) to the connector housing (2).
Fasten the cable (3) with tie band to the connector housing (2).
71812D
2.INSTALL FRONT SEAT CUSHION SHIELD (for Power Seat)
71812D
3.INSTALL FRONT SEAT CUSHION SHIELD (for Manual Seat)
72495
4.INSTALL VERTICAL ADJUSTING HANDLE (for Manual Seat)
71822
5.INSTALL FRONT SEAT SIDE SHIELD (for Manual Seat)
6.INSTALL FRONT SEAT SIDE SHIELD (for Manual Seat)
71862
7.INSTALL FRONT SEAT CUSHION INNER SHIELD
8.INSTALL FRONT SEAT ASSEMBLY
for Manual Seat:
Click hereVehicle Interior>SEAT>FRONT SEAT ASSEMBLY (for Manual Seat)>INSTALLATION
for Power Seat:
Click hereVehicle Interior>SEAT>FRONT SEAT ASSEMBLY (for Power Seat)>INSTALLATION