Use the same procedure for both the LH and RH sides.
The procedure described below is for the LH side.
53510
1.INSTALL HOOD LOCK ASSEMBLY
|
Install in this Direction |
Attach the cable (2) to the hood lock assembly (1).
Install the hood lock assembly (1) in the downward direction.
Replace the T30 screws (2).
Tighten the T30 screws (2).
Attach the clamp (1).
Connect the connectors (2).
Attach the clamps (1).
Attach the No. 5 water by-pass hose to the radiator reserve tank assembly.
53470
2.INSTALL POP UP HOOD LIFTER ASSEMBLY
Check that the START-STOP button (engine switch) off.
Pressing and holding the AUDIO button changes the power source mode to IG OFF.
Check that the cable is disconnected from the negative (-) battery terminal.
Wait at least 60 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
If the airbag deploys for any reason, it may cause a serious accident.
Insert the pop up hood lifter assembly (1) into the guide pin (4) and push towards the rear up to the limit position in direction of arrow.
Replace the T30 bolt (2).
Tighten the T30 bolt (2).
Connect and engage the connectors (3).
Attach the clamp (2) and return the cowl ventilator splash shield (1) to its original position as shown by the arrow in the illustration.
55781E
3.INSTALL COWL TOP VENTILATOR LOUVER SUB-ASSEMBLY
53826A
4.INSTALL UPPER FRONT FENDER PROTECTOR LH
5.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
for B48:
for B58: