Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › CENTER AIRBAG SENSOR ASSEMBLY
RM3650E _58 Vehicle Interior _079907 SUPPLEMENTAL RESTRAINT SYSTEMS _0387809 CENTER AIRBAG SENSOR ASSEMBLY A

SUPPLEMENTAL RESTRAINT SYSTEMS  CENTER AIRBAG SENSOR ASSEMBLY  REMOVAL  


CAUTION / NOTICE / HINT

CAUTION:
·

Working on 12 V vehicle electrical system.

Risk of short circuits! Risk of fire!

-

Detach the cable from the negative (-) battery terminal.



·
B475753

Pyrotechnic components.

Danger! Life-threatening injuries!

-

All work on pyrotechnic parts may be carried out by technically experienced and appropriately trained personnel only.

-

Replace any damaged part or ones that have been dropped.



·

Wait at least 60 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

·

If the airbag deploys for any reason, it may cause a serious accident.



NOTICE:
·

Before performing work on electronic components, disconnect the cable from the negative (-) battery terminal to prevent damage to the electrical system or components.

·

When disconnecting the cable, turn the START-STOP button (engine switch) and headlight switch off and loosen the cable nut completely. Perform these operations without twisting or prying on the cable. Then disconnect the cable.

·

Clock settings, radio settings, audio system memory, DTCs and other data will be cleared when the cable is disconnected from the negative (-) battery terminal. Write down any necessary data before disconnecting the cable.



PROCEDURE

Hide 58801D 1.REMOVE CONSOLE BOX ASSEMBLY

Hide 89170A 2.REMOVE AIRBAG ECU ASSEMBLY

NOTICE:
·

Electrostatic discharge.

Damage to or destruction of electrical components.

-

Only touch the housings of electrical components. Do not touch pins or multi-pin connectors directly.

-

For additional information see:

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION




a.

Check that the START-STOP button (engine switch) off.

HINT:
A439562

Pressing and holding the AUDIO button changes the power source mode to IG OFF.



b.

Check that the cable is disconnected from the negative (-) battery terminal.

CAUTION:
·

Wait at least 60 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

·

If the airbag deploys for any reason, it may cause a serious accident.




c.
B538717

Unlock the plug connection (1) and disconnect.


d.
B538718

Loosen the nuts (1).


e.

Remove the airbag ECU assembly (2).