Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › REAR AIRBAG SENSOR
RM3650E _58 Vehicle Interior _079907 SUPPLEMENTAL RESTRAINT SYSTEMS _0387812 REAR AIRBAG SENSOR A

SUPPLEMENTAL RESTRAINT SYSTEMS  REAR AIRBAG SENSOR  INSTALLATION  


PROCEDURE

Hide 89174 1.INSTALL AIRBAG SENSOR (for LH Side)

CAUTION:
·

Malfunction with incorrectly secured components.

·

Danger of injury!

-

Ask a second person to check the torque or latch mechanism (four-eyes principle).

-

Both persons must document that the work has been carried out correctly in the vehicle records.




a.

Check that the START-STOP button (engine switch) off.

HINT:
A439562

Pressing and holding the AUDIO button changes the power source mode to IG OFF.



b.

Check that the cable is disconnected from the negative (-) battery terminal.

CAUTION:
·

Wait at least 60 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

·

If the airbag deploys for any reason, it may cause a serious accident.




c.
B538722

Attach the guide (4) to install the airbag sensor (3).


d.

Replace the T30 bolt (2).


e.

Tighten the T30 bolt (2).

Torque:
8.0 N*m (82 kgf*cm, 71 in.*lbf)


f.

Connect connectors (1) and lock.


Hide 89174 2.INSTALL AIRBAG SENSOR (for RH Side)

HINT:

Use the same procedure as for the LH side.


Hide 3.INSTALL QUARTER TRIM LOWER PANEL RH (for RH Side)

HINT:

Use the same procedure as for the LH side.


Click hereAudio / Visual / Telematics>AUDIO / VIDEO>LUGGAGE SPEAKER>INSTALLATION

Hide 67913 4.INSTALL FRONT DOOR SCUFF PLATE RH (for RH Side)

HINT:

Use the same procedure as for the LH side.


Click hereVehicle Interior>INTERIOR PANELS / TRIM>INSTRUMENT PANEL SAFETY PAD>INSTALLATION

Hide 62636A 5.INSTALL QUARTER TRIM UPPER PANEL

Hide 6.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL