Home › Engine / Hybrid System › B58 (INTAKE / EXHAUST) › TURBO CHARGER ACTUATOR AND LINK › 2019.03–2020.03
RM3650E _51 Engine / Hybrid System _080024 B58 INTAKE / EXHAUST _0388152 TURBO CHARGER ACTUATOR AND LINK A

B58 INTAKE / EXHAUST  TURBO CHARGER ACTUATOR AND LINK  REMOVAL  


CAUTION / NOTICE / HINT

CAUTION:
·

Hot surfaces.

Risk of burning!

-

Perform all work only on components that have cooled down.




PROCEDURE

Hide 17880 1.REMOVE AIR CLEANER HOSE ASSEMBLY

Hide 17240 3.REMOVE TURBOCHARGER ACTUATOR AND LINK ASSEMBLY

CAUTION:
·

Hot surfaces.

Risk of burning!

-

Perform all work only on components that have cooled down.




NOTICE:
·

Damage to the turbocharger actuator and link assembly and the mechanical connection.

Improper handling of the turbocharger actuator and link assembly can lead to malfunctions or failure of the turbocharger actuator and link assembly.

-

Avoid exposure of lateral forces to the control rod of the turbocharger actuator and link assembly.


·

Electrostatic discharge.

Damage to or destruction of electrical components.

-

Only touch the housings of electrical components. Do not touch pins or multi-pin connectors directly.

-

For additional information see:

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION




HINT:

It is not necessary to adjust the turbocharger actuator and link assembly after removing and installing or renewing.


a.
C411710

Unlock and loosen connector (1).


b.
C411711

Unlock and detach retaining clip (1).


c.
C411712

Loosen the T25 bolts (1) on the turbocharger actuator and link assembly (2).


d.
C411713

Guide the turbocharger actuator and link assembly (3) out of the compressor housing bore hole (4) in the direction of arrow and remove it.

NOTICE:
·

Carefully pull the control rod (1) of the turbocharger actuator and link assembly (3) off the pin on the lever of the wastegate valve (2).

·

Any effect of lateral force on the control rod (1) must be avoided.