Home › Engine / Hybrid System › B48 (ENGINE CONTROL) › SERVO MOTOR
RM3650E _51 Engine / Hybrid System _080056 B48 ENGINE CONTROL _0388304 SERVO MOTOR A

B48 ENGINE CONTROL  SERVO MOTOR  INSTALLATION  


PROCEDURE

Hide 15330G 1.INSTALL SERVO MOTOR

a.
A441638

Replace O-ring (1).


b.
A441639

Push the O-ring (1) onto the housing to the limit position.


c.
A441208

Insert the servo motor (1) to the gearing.


d.

Using a 4 mm hexagon socket wrench (2), turn the drive shaft of the servo motor (1) in the direction of the arrow until the servo motor (1) is flush with the cylinder head sub-assembly.


e.
A442147

Tighten the T30 bolts (1).

Torque:
10 N*m (102 kgf*cm, 7 ft.*lbf)


f.

Connect connector.


Hide 12180E 4.INSTALL OIL FILLER CAP ASSEMBLY