Home › Engine / Hybrid System › B48 (LUBRICATION) › LUBRICATION SYSTEM
RM3650E _51 Engine / Hybrid System _080065 B48 LUBRICATION _0388369 LUBRICATION SYSTEM G

B48 LUBRICATION  LUBRICATION SYSTEM  ON-VEHICLE INSPECTION  


CAUTION / NOTICE / HINT

CAUTION:
·

Hot surfaces.

Risk of burning!

-

Perform all work only on components that have cooled down.



·

Hot fluids.

Risk of scalding!

-

Conduct all work in the vehicle wearing appropriate personal protective equipment only.



·

Collect and dispose of emerging fluids. Observe country-specific waste disposal regulations.



PROCEDURE

Hide 1.CHECK ENGINE OIL LEVEL

HINT:

Always check the engine oil level when the engine is at operating temperature (engine oil temperature > 70°C).

Vehicle information / Control unit list / DME / Call up control unit functions / Diagnostic request / Diagnostic request / 103 Engine oil tempreture


a.

Park vehicle on a horizontal surface.


b.

Stop engine.


c.

Wait approximately 5 minutes.


d.

When using the diagnosis system:

i.

Connect the diagnosis system to the vehicle and enter the following menus:

Vehicle management / Service functions / Drive / Engine electronics / Engine oil / Motor oil quantity



e.

When not using the diagnosis system:

i.

Read off the engine oil level in the combination meter assembly or on the multi-display assembly



f.

Top up engine oil if necessary.


Hide 2.INSPECT OIL PRESSURE

a.

Remove the No. 1 engine cover sub-assembly.

Click hereEngine / Hybrid System>B48 (ENGINE MECHANICAL)>ENGINE ASSEMBLY>REMOVAL


b.

Remove the oil filter cap assembly.

Click hereGeneral>MAINTENANCE>B48 OIL AND OIL FILTER>REPLACEMENT


c.

Remove the oil filter element.

Click hereGeneral>MAINTENANCE>B48 OIL AND OIL FILTER>REPLACEMENT


d.
A444621

Install the oil filter element (1) in the special tool 2 289 603.

SST
09200-WA970  


e.

If necessary, install O-ring (2).


f.

Apply a small amount of engine oil to the O-ring.


g.
A444613

Using a 32 mm socket wrench, install and tighten the special tool 2 289 603.

SST
09200-WA970  

Torque:
25 N*m (255 kgf*cm, 18 ft.*lbf)


h.

Connect special tool 0 491 260 (13 3 061) with special tools 0 491 262 (13 3 063) and 2 289 603.

SST
09200-WA970  09200-WA930  09200-WA950  


i.

Start the engine.


j.

Measure the oil pressure, and check that the oil pressure changes according to engine speed.


k.

Stop the engine.


l.
A444613

Remove special tools 0 491 260 (13 3 061), 0 491 262 (13 3 063) and 2 289 603.

SST
09200-WA970  09200-WA930  09200-WA950  


m.
A444621

Detach the oil filter element (1) from the special tool 2 289 603.

SST
09200-WA970  


n.

If necessary, remove O-ring (2).


o.

Install the oil filter element.

Click hereGeneral>MAINTENANCE>B48 OIL AND OIL FILTER>REPLACEMENT


p.

Install the oil filter cap assembly.

Click hereGeneral>MAINTENANCE>B48 OIL AND OIL FILTER>REPLACEMENT


q.

Install the No. 1 engine cover sub-assembly.

Click hereEngine / Hybrid System>B48 (ENGINE MECHANICAL)>ENGINE ASSEMBLY>INSTALLATION