Home › Engine / Hybrid System › B48 (ENGINE CONTROL) › ENGINE WIRE HARNESS (for No. 4)
RM3650E _51 Engine / Hybrid System _080056 B48 ENGINE CONTROL _0388317 ENGINE WIRE HARNESS(for No. 4) A

B48 ENGINE CONTROL  ENGINE WIRE HARNESS(for No. 4)  REMOVAL  


CAUTION / NOTICE / HINT

CAUTION:
·

Working on 12 V vehicle electrical system.

Risk of short circuits! Risk of fire!

-

Detach battery earth lead from battery.




NOTICE:
·

Damage to battery terminal, the safety battery terminal or the battery state sensor.

Damaged battery terminals can lead to malfunctions or vehicle electrical system faults.

-

Pull off battery terminal from battery pole by carefully moving to and fro. Do not pry off using a tool.




PROCEDURE

Hide 1.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

Hide 53681 2.REMOVE UPPER FRONT SUSPENSION CENTER BRACE

Hide 12601B 3.REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY

Hide 55788A 4.REMOVE COWL TOP VENTILATOR LOUVER PROTECTOR

Hide 11271A 5.REMOVE REAR CYLINDER BLOCK COVER

Hide 82124 6.REMOVE NO. 4 ENGINE WIRE

NOTICE:
·

Damage to wires when disconnecting connectors and plug connections.

Sheared wires can cause a short circuit.

-

Do not pull on the wires when disconnecting connectors and plug connections.




a.
A442111

Release snap-lock couplings (1).


b.

Feed the engine room ECU cover (2) out toward the top and remove.


c.
A442155

Unlock and loosen all connectors (1) in the direction of the arrow.


d.
A442157

Unlock and detach all connectors (arrows).


e.
A442156

Unlock all connectors (arrows) on the injectors and disconnect.


f.
A441736

Push the lock (1) upward in the direction of the arrow.


g.

Press lock (1) together and release.


h.

Pull off the connector (2) from the injectors.


i.
A442219

Loosen clamp (1).


j.

Unlock the holder (2).


k.

Unlock the holder (3).


l.

Unlock the holder (4).


m.
A442172

Unfasten nut (1).


n.

Unclip and remove No. 4 engine wire (2) in the marked area.