Home › Engine / Hybrid System › B58 (ENGINE CONTROL) › ENGINE WIRE HARNESS
RM3650E _51 Engine / Hybrid System _080064 B58 ENGINE CONTROL _0388339 ENGINE WIRE HARNESS A

B58 ENGINE CONTROL  ENGINE WIRE HARNESS  INSTALLATION  


PROCEDURE

Hide 82124 1.INSTALL NO. 4 ENGINE WIRE

NOTICE:
·

Improper routing of cables and wiring harnesses.

Trapped, crushed or damaged cables may cause short circuits and malfunctions.

-

Route all cables without abrasions, do not trap and crush.




a.

Guide in and install the No. 4 engine wire section for the ignition and injectors.


b.

Connect connector (1) to ECM.


c.
A442178

Secure the No. 4 engine wire at the bracket (2).


d.

Fasten No. 4 engine wire with the clamp (3).


e.

Fasten No. 4 engine wire with the clamp (4).


f.
A442179

Connect and lock all connectors (1) on the ignition coils.


g.

Mount both ground cables and tighten the nuts (2).

Torque:
5.0 N*m (51 kgf*cm, 44 in.*lbf)


h.

Connect and lock all connectors (3) to the injectors.


i.
A441737

Connect the connector to the injectors.


j.

Engage lock (1) in direction of arrow audibly.


k.
A442112

Connect all connectors (1) and lock.

HINT:

All connectors (1) must engage audibly.



l.
A442111

Install the cover (2).

HINT:

The snap-lock couplings (1) must engage audibly.



Hide 12601B 3.INSTALL NO. 1 ENGINE COVER SUB-ASSEMBLY

Hide 55788A 4.INSTALL COWL TOP VENTILATOR LOUVER PROTECTOR

Hide 53681 5.INSTALL UPPER FRONT SUSPENSION CENTER BRACE

Hide 6.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL