Home › Vehicle Interior › SEAT › POWER SEAT SWITCH
RM3650E _58 Vehicle Interior _080097 SEAT _0388586 POWER SEAT SWITCH A

SEAT  POWER SEAT SWITCH  REMOVAL  


CAUTION / NOTICE / HINT

CAUTION:
·
B475753

Airbag unit.

Danger! Life-threatening injuries!

-

Before performing any work on the airbag, always disconnect the battery earth lead from the battery.

-

Airbag unit may only be set down with the cushion (airbag itself) facing upwards.

-

All work on pyrotechnic parts may be carried out by technically experienced and appropriately trained personnel only.

-

Replace any damaged part or ones that have been dropped.


·

Wear protective gloves. Sharp areas on the parts may injure your hands.



NOTICE:
·

Before performing work on electronic components, disconnect the cable from the negative (-) battery terminal to prevent damage to the electrical system or components.

·

When disconnecting the cable, turn the START-STOP button (engine switch) and headlight switch off and loosen the cable nut completely. Perform these operations without twisting or prying on the cable. Then disconnect the cable.

·

Clock settings, radio settings, audio system memory, DTCs and other data will be cleared when the cable is disconnected from the negative (-) battery terminal. Write down any necessary data before disconnecting the cable.



HINT:
·

Use the same procedure for RHD and LHD vehicles.

·

The procedure listed below is for LHD vehicles.

·

Use the same procedure for the driver side and front passenger side.

·

The procedure listed below is for the driver side.



PROCEDURE

Hide 71812D 2.REMOVE FRONT SEAT CUSHION SHIELD

Hide 3.REMOVE FRONT POWER SEAT SWITCH (for Driver Side)

a.
B539406

Disconnect the connector (1).


b.

Disengage the claws (2) and guides (3) to remove the power seat switch (4).


Hide 4.REMOVE FRONT POWER SEAT SWITCH (for Front Passenger Side)

a.
B539407

Disconnect the connector (1).


b.

Disengage the claws (2) and guides (3) to separate the power seat switch (4).


c.
B539408

Disconnect the connector (1) to remove the power seat switch (2).