1.DISCONNECT CABLE TO NEGATIVE BATTERY TERMINAL
Click hereGeneral>MAINTENANCE>B48 BATTERY>REMOVAL
2.REMOVE IGNITION COIL ASSEMBLY
89458
3.REMOVE FUEL PRESSURE SENSOR
Working on fuel system.
Risk of fire! Danger of explosion!
When working on the fuel system, make sure that the workbay is sufficiently ventilated, e.g. using extraction unit.
Tightly seal off open lines and connections; collect any escaping fuel directly at the point of exit.
No fire, sparks, open flames or smoking.
On releasing high pressure line, fuel may emerge at high speed.
Danger of injury!
Wear suitable personal protective equipment.
Allow the cooling system to cool down to a temperature below 40°C before starting installation work.
Note warnings on cylinder head cover.
Electrostatic discharge.
Damage to or destruction of electrical components.
Only touch the housings of electrical components. Do not touch pins or multi-pin connectors directly.
For additional information see:
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
Contaminant or foreign body.
Contamination can result in malfunctions, operating failure or leaks.
Adhere to the utmost cleanliness.
Protect components from contamination e.g. by covering.
Close off line connections with seal plugs.
Collect and dispose of emerging fluids. Observe country-specific waste disposal regulations.
Unlock plug connection (1) and disconnect.
Release the rail pressure sensor (1) with the special tool 0 492 027 (32 2 100) and remove.
Catch and dispose of escaping fuel.