1.INSTALL FUEL FILLER PIPE
Thread the fuel filler pipe (1) with the associated tank ventilation line upward.
Connect the rubber hose (2) with the fuel tank.
Renew the hose clamp (1).
Tighten the hose clamp (1).
Connect and lock the snap fastener (1).
Tighten nuts (2) and (3).
Connect and lock the snap fastener (1).
Clip the tank ventilation line into the brackets (2).
Check the sealing lip (1) on the wheel arch for correct fit.
57628E
2.INSTALL REAR FLOOR SIDE MEMBER COVER LH
65637
3.INSTALL REAR WHEEL HOUSE LINER RH
4.INSTALL WHEEL ASSEMBLY
5. FILLING THE FUEL TANK WITH FUEL