89465
1.REMOVE OXYGEN SENSOR
89467A
2.REMOVE WIDE RANGE AIR FUEL RATIO SENSOR
3.REMOVE EXHAUST PIPE ASSEMBLY
25051
4.REMOVE EXHAUST MANIFOLD CONVERTER SUB-ASSEMBLY
Hot surfaces.
Risk of burning!
Perform all work only on components that have cooled down.
Heavy component.
Heavy components can lead to injury or damage.
Remove and install heavy components with the aid of another person/other persons.
w/ Differential Pressure Sensor
Pull off the vacuum transmitting hose assembly (1).
Loosen screw (1).
Bend up exhaust pipe clamp (2).
Loosen nuts (1).
Remove the exhaust manifold converter sub-assembly toward the bottom.