Home › Engine / Hybrid System › B58 (EMISSION CONTROL) › MONOLITHIC CONVERTER
RM3650E _51 Engine / Hybrid System _080101 B58 EMISSION CONTROL _0388648 MONOLITHIC CONVERTER A

B58 EMISSION CONTROL  MONOLITHIC CONVERTER  INSTALLATION  


PROCEDURE

Hide 25051 1.INSTALL EXHAUST MANIFOLD CONVERTER SUB-ASSEMBLY

a.
A441590

Replace the exhaust pipe clamp (1).


b.
A441589

Replace gasket (1).


c.

Feed in and install exhaust manifold converter sub-assembly together with the exhaust pipe clamp.


d.
A442394

Replace nuts (1).


e.

Screw on nuts (1) by a few turns.

HINT:
A442393

·

Note the installation position of the component. The component may be installed in various installation positions.




f.

Position exhaust pipe clamp (2).


g.

Tighten down screw (1).

Torque:
19 N*m (194 kgf*cm, 14 ft.*lbf)


h.
A442394

Tighten nuts (1).

Torque:
28 N*m (286 kgf*cm, 21 ft.*lbf)


i.

w/ Differential Pressure Sensor

i.

Connect the vacuum transmitting hose assembly.



Hide 89467A 3.INSTALL WIDE RANGE AIR FUEL RATIO SENSOR