Home › Engine / Hybrid System › B48 (STARTING) › STARTER WIRING ASSEMBLY
RM3650E _51 Engine / Hybrid System _080068 B48 STARTING _0388696 STARTER WIRING ASSEMBLY A

B48 STARTING  STARTER WIRING ASSEMBLY  REMOVAL  


CAUTION / NOTICE / HINT

CAUTION:
·

Working on 12 V vehicle electrical system.

Risk of short circuits! Risk of fire!

-

Disconnect the cable from the negative (-) battery terminal.



·

Hot surfaces.

Risk of burning!

-

Perform all work only on components that have cooled down.




PROCEDURE

Hide 1.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

Hide 12601B 2.REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY

Hide 51219 3.REMOVE FRONT SUSPENSION MEMBER LOWER PROTECTOR

Hide 4.REMOVE STARTER WIRING ASSEMBLY

a.
A441478

Unlock the locks (1).


b.

Guide and remove terminal cover (2) in the direction of the arrow.


c.
A442127

Unfasten nut (1).


d.

Loosen clamps (2).


e.

Feed out starter wiring assembly (3) and put to one side.


f.
A442128

Unfasten nut (1).


g.

Thread out starter wiring assembly (2) and set it aside.


h.
A442129

Loosen nuts (1).


i.

Guide the No. 2 front floor heat Insulator (2) out and remove it.


j.
A441487

Release the clamps (arrows).


k.

Remove starter wiring assembly (1).