Working on 12 V vehicle electrical system.
Risk of short circuits! Risk of fire!
Disconnect the cable from the negative (-) battery terminal.
Hot surfaces.
Risk of burning!
Perform all work only on components that have cooled down.
1.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
Click hereGeneral>MAINTENANCE>B58 BATTERY>REMOVAL
12601B
2.REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY
51219
3.REMOVE FRONT SUSPENSION MEMBER LOWER PROTECTOR
4.REMOVE STARTER WIRING ASSEMBLY
Unlock the locks (1).
Guide and remove terminal cover (2) in the direction of the arrow.
Unfasten nut (1).
Loosen clamps (2).
Feed out starter wiring assembly (3) and put to one side.
Unfasten nut (1).
Thread out starter wiring assembly (2) and set it aside.
Loosen nuts (1).
Guide the No. 2 front floor heat Insulator (2) out and remove it.
Release the clamps (arrows).
Remove starter wiring assembly (1).