Home › Engine / Hybrid System › B58 (STARTING) › STARTER WIRING ASSEMBLY
RM3650E _51 Engine / Hybrid System _080073 B58 STARTING _0388699 STARTER WIRING ASSEMBLY A

B58 STARTING  STARTER WIRING ASSEMBLY  INSTALLATION  


PROCEDURE

Hide 1.INSTALL STARTER WIRING ASSEMBLY

CAUTION:
·

Improper routing of the positive battery cable.

·

Risk of short circuits!

-

Route the positive battery cable without abrasions and do not trap.




a.
A441487

Insert and install the starter wiring assembly (1).


b.

Secure the clamps (arrows).


c.
A442129

Insert and install the No. 2 front floor heat Insulator (2).


d.

Tighten nuts (1).

Torque:
3.0 N*m (31 kgf*cm, 27 in.*lbf)


e.
A442176

Position the starter wiring assembly (2) to the starter assembly.


f.

Tighten nut (1).

Torque:
13.5 N*m (138 kgf*cm, 10 ft.*lbf)


g.
A442127

Position the starter wiring assembly (3) to the positive battery terminal.


h.

Secure clamps (2).


i.

Tighten nut (1).

Torque:
19 N*m (194 kgf*cm, 14 ft.*lbf)


j.
A441479

Insert and install the terminal cover (2) in the direction of the arrow.

HINT:

The locks (1) must engage audibly.



Hide 51219 2.INSTALL FRONT SUSPENSION MEMBER LOWER PROTECTOR

Hide 12601B 3.INSTALL NO. 1 ENGINE COVER SUB-ASSEMBLY

Hide 4.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL