Home › Power Source / Network › B48 (BATTERY / CHARGING) › GENERATOR
RM3650E _57 Power Source / Network _080072 B48 BATTERY / CHARGING _0388700 GENERATOR A

B48 BATTERY / CHARGING  GENERATOR  INSTALLATION  


PROCEDURE

Hide 16620D 1.INSTALL V-RIBBED BELT TENSIONER ASSEMBLY

Hide 27020 2.INSTALL GENERATOR ASSEMBLY

a.
A441482C02
0.417,0.125 1.083,0.302 0.667,0.177 10 true *a
*a 4 mm Hexagon Wrench


Make sure that the 4 mm hexagon wrench is fitted correctly.


b.

Slightly push back the threaded support sleeve (2) in the direction of the arrow to facilitate the installation of the generator assembly.


c.

Screw the bolt (1) into the threaded support sleeve (2).


d.

Press back the threaded support sleeve (2) using the bolt (1).


e.

Once again unscrew the bolt (1) from the threaded support sleeve (2).


f.
A441480C02
2.354,1.26 3.01,1.438 0.656,0.177 10 true *a
*a 4 mm Hexagon Wrench


Insert and install the generator assembly (2).


g.

Tighten the E12 bolts (1).

Torque:
38 N*m (387 kgf*cm, 28 ft.*lbf)


h.
A442125

Insert and install the generator wire (2).


i.

Tighten nut (1).

Torque:
19 N*m (194 kgf*cm, 14 ft.*lbf)


j.

Connect and lock the connector (3).

HINT:

The connector must engage audibly.



k.

Guide in the holder with the radiator reserve tank hose, No.2 radiator hose and water by-pass hose and install.


Hide 3.INSTALL COMPRESSOR WITH PULLEY ASSEMBLY

a.

Position the compressor with magnet clutch (2).


b.
A442123

Tighten the E12 bolts (1).

Torque:
38 N*m (387 kgf*cm, 28 ft.*lbf)


Hide 22267 4.INSTALL THROTTLE BODY BRACKET

a.
A441861

Position throttle body bracket (2).


b.

Tighten the E8 bolts (1).

Torque:
8.0 N*m (82 kgf*cm, 71 in.*lbf)


c.
A441860

Clip the engine wire harness (1) into the throttle body bracket (2).


d.
A441859

Clip the wiring harness (1) into the throttle body bracket (2).


e.
A441858

Clip the water by-pass hose (1) into the throttle body bracket (2).


Hide 5.INSTALL FAN AND GENERATOR V BELT

Hide 22030 6.INSTALL THROTTLE BODY WITH MOTOR ASSEMBLY

Hide 7.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL