Home › Power Source / Network › B58 (BATTERY / CHARGING) › GENERATOR
RM3650E _57 Power Source / Network _080074 B58 BATTERY / CHARGING _0388706 GENERATOR A

B58 BATTERY / CHARGING  GENERATOR  REMOVAL  


PROCEDURE

Hide 1.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

Hide 2.REMOVE FAN AND GENERATOR V BELT

Hide 17882 3.REMOVE NO. 2 AIR CLEANER HOSE

Hide 27020 4.REMOVE GENERATOR ASSEMBLY

CAUTION:
·

Working on 12 V vehicle electrical system.

Risk of short circuits! Risk of fire!

-

Disconnect the cable from the negative (-) battery terminal.



·

Hot surfaces.

Risk of burning!

-

Perform all work only on components that have cooled down.




NOTICE:
·

Electrostatic discharge.

·

Damage to or destruction of electrical components.

-

Leave electrical components in original packaging until just before they are installed. Use the original packaging only for any return shipments. Always package removed components straight away.

-

Only touch the housings of electrical components. Do not touch pins or multi-pin connectors directly.

-

Anti static work clothing and antistatic shoes (with ESD symbol).

-

For additional information see:

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION




a.
A442125

Unfasten nut (1).


b.

Thread out generator wire (2) and set it aside.


c.

Unlock and loosen connector (3).


d.
A441480C02
2.354,1.26 3.01,1.438 0.656,0.177 10 true *a
*a 4 mm Hexagon Wrench


Make sure that the 4 mm hexagon wrench is fitted correctly.


e.

Loosen E12 bolts (1).


f.

Guide out generator assembly (2) and remove.


Hide 16620D 5.REMOVE V-RIBBED BELT TENSIONER ASSEMBLY

CAUTION:
·

Danger of injury!

-

Reduce preload as far as possible before disassembly. Relieve component.




a.
A441481C02
0.51,1.833 1.146,2.01 0.635,0.177 10 true *a
*a 4 mm Hexagon Wrench


Remove bolts (arrows).


b.

Guide out v-ribbed belt tensioner assembly (1) and remove.


c.

Make sure that the 4 mm hexagon wrench is fitted correctly.