17882
1.REMOVE NO. 2 AIR CLEANER HOSE
51219
2.REMOVE FRONT SUSPENSION MEMBER LOWER PROTECTOR
3. DRAIN ENGINE COOLANT (for High Temperature)
11401T
4.REMOVE CYLINDER BLOCK COVER
16173
5.LOOSEN WATER PUMP PULLEY
Loosen T30 bolts (1).
Slacken the bolts by 180° only. Do not unscrew completely.
6.REMOVE FAN AND GENERATOR V BELT
16100
7.REMOVE ENGINE WATER PUMP ASSEMBLY
Collect and dispose of emerging fluids. Observe country-specific waste disposal regulations.
Loosen T30 bolts (1).
Remove the water pump pulley (2).
| *a | 4 mm Hexagon Wrench |
Increase preload at belt tensioner (1).
Component with preload.
Danger of injury!
Reduce preload as far as possible before disassembly. Relieve component.
Remove the 4 mm hexagon wrench from belt tensioner (1).
Relieve tension at belt tensioner (1).
Loosen T30 bolts (1).
Remove the No. 2 water by-pass hose (2) and tie it to the side.
Catch and dispose of escaping coolant.
Loosen T30 bolts (1).
Catch and dispose of escaping coolant.
Feed out and remove the engine water pump assembly (2).