Home › Engine / Hybrid System › B48 (COOLING) › WATER PUMP
RM3650E _51 Engine / Hybrid System _080127 B48 COOLING _0388807 WATER PUMP A

B48 COOLING  WATER PUMP  INSTALLATION  


PROCEDURE

Hide 16100 1.INSTALL ENGINE WATER PUMP ASSEMBLY

NOTICE:

The sealing surfaces must be free from oils, grease and cleaning agents.


a.
A441270

Clean sealing surface (1).


b.
A514360

Apply sealing bead (1) in a continuous line.

Seal Packing:

Loctite 5970 Flange Sealant


Height of the sealing bead:

2.0 to 2.5 mm (0.08 to 0.10 in.)


Processing time of liquid sealing compound:

12 minutes or more



c.
A514361

Check the guide sleeve (1) for correct fit.


d.
A441834

Position engine water pump assembly (2).


e.

Tighten the T30 bolts (1).

Torque:
10 N*m (102 kgf*cm, 7 ft.*lbf)


f.
A441900

Replace the O-ring (1).


g.

Clean sealing surface of the engine water pump assembly.


h.
A441833

Position the No. 2 water by-pass hose (2).


i.

Tighten the T30 bolts (1).

Torque:
8.0 N*m (82 kgf*cm, 71 in.*lbf)


j.
A445282C03
2.031,1.823 2.5,1.5 true 2.49,1.375 2.802,1.531 0.313,0.156 10 true *a
*a 4 mm Hexagon Wrench


Increase preload at belt tensioner (1).

CAUTION:
·

Component with preload.

Danger of injury!

-

Reduce preload as far as possible before disassembly. Relieve component.





k.

Secure the belt tensioner (1) with the 4 mm hexagon wrench.


l.
A441821

Position the water pump pulley (2).


m.

Screw the T30 bolts (1) in a few turns.


Hide 2.INSTALL FAN AND GENERATOR V BELT

Hide 16173 3.TIGHTEN WATER PUMP PULLEY

a.
A441268

Tighten the T30 bolts (1).

Torque:
8.0 N*m (82 kgf*cm, 71 in.*lbf)


Hide 11401T 4.INSTALL CYLINDER BLOCK COVER

Hide 6.ADD ENGINE COOLANT (for High Temperature)

Hide 7.INSPECT FOR COOLANT LEAK (for High Temperature)

Hide 51219 8.INSTALL FRONT SUSPENSION MEMBER LOWER PROTECTOR