Hot fluids.
Risk of scalding!
Conduct all work in the vehicle wearing appropriate personal protective equipment only.
Hot surfaces.
Risk of burning!
Perform all work only on components that have cooled down.
Life-long fill of coolant!
Do not reuse used coolant.
When replacing and removing components which rely on the corrosion protection effect of the coolant, it is essential to change the coolant. The cooling system must therefore be emptied and refilled.
In the case of other removal work involving the draining of part quantities of coolant, the coolant level must be topped up with new coolant.
Collect and dispose of emerging fluids. Observe country-specific waste disposal regulations.
1.REMOVE WHEEL ASSEMBLY
53879
2.REMOVE FRONT FENDER LINER LH
51219
3.REMOVE FRONT SUSPENSION MEMBER LOWER PROTECTOR
4. DRAIN ENGINE COOLANT (for High Temperature)
16420
5.REMOVE SUB RADIATOR ASSEMBLY
Disconnect the coolant lines with the special tool.
Unlock and pull off radiator hose sub-assembly and No. 3 radiator hose (1).
Catch and dispose of escaping coolant.
Detach the clip in the marked area.
Loosen T45 bolts (1).
Guide the sub radiator assembly (1) with the auxiliary coolant radiator bracket plate LH (2) out and remove it.