Home › Engine / Hybrid System › B58 (COOLING) › SUB RADIATOR (for LH Side)
RM3650E _51 Engine / Hybrid System _080128 B58 COOLING _0388827 SUB RADIATOR(for LH Side) A

B58 COOLING  SUB RADIATOR(for LH Side)  INSTALLATION  


CAUTION / NOTICE / HINT

CAUTION:
·

Hot surfaces.

Risk of burning!

-

Perform all work only on components that have cooled down.




NOTICE:
·

Life-long fill of coolant!

·

Do not reuse used coolant.

When replacing and removing components which rely on the corrosion protection effect of the coolant, it is essential to change the coolant. The cooling system must therefore be emptied and refilled.

In the case of other removal work involving the draining of part quantities of coolant, the coolant level must be topped up with new coolant.

·

Collect and dispose of emerging fluids. Observe country-specific waste disposal regulations.



PROCEDURE

Hide 16420 1.INSTALL SUB RADIATOR ASSEMBLY

a.
A442344

Guide in the sub radiator assembly (1) with the auxiliary coolant radiator bracket plate LH (2) and install.


b.

Make sure you can feel the sub radiator supports (3) engage in the body.


c.
A442343

Tighten the T45 bolts (1).

Torque:
19 N*m (194 kgf*cm, 14 ft.*lbf)


d.
A442342

Connect the radiator hose sub-assembly and No. 3 radiator hose (1) to the left auxiliary coolant radiator and lock.

HINT:

Make sure that the connections are locked correctly. The locks must engage audibly.



e.

Detach the special tool from the radiator hose sub-assembly and No. 3 radiator hose (1) and guide out.


f.

Mount the clip in the marked area.


Hide 53879 2.INSTALL FRONT FENDER LINER LH

Hide 3.INSTALL WHEEL ASSEMBLY

Hide 4.ADD ENGINE COOLANT (for High Temperature)

Hide 5.INSPECT FOR COOLANT LEAK (for High Temperature)

Hide 51219 6.INSTALL FRONT SUSPENSION MEMBER LOWER PROTECTOR