Home › Engine / Hybrid System › B58 (COOLING) › SUB RADIATOR (for RH Side)
RM3650E _51 Engine / Hybrid System _080128 B58 COOLING _0388828 SUB RADIATOR(for RH Side) A

B58 COOLING  SUB RADIATOR(for RH Side)  REMOVAL  


CAUTION / NOTICE / HINT

CAUTION:
·

Hot surfaces.

Risk of burning!

-

Perform all work only on components that have cooled down.



·

Hot fluids.

Risk of scalding!

-

Conduct all work in the vehicle wearing appropriate personal protective equipment only.




NOTICE:
·

Life-long fill of coolant!

·

Do not reuse used coolant.

When replacing and removing components which rely on the corrosion protection effect of the coolant, it is essential to change the coolant. The cooling system must therefore be emptied and refilled.

In the case of other removal work involving the draining of part quantities of coolant, the coolant level must be topped up with new coolant.

·

Collect and dispose of emerging fluids. Observe country-specific waste disposal regulations.



PROCEDURE

Hide 1.REMOVE WHEEL ASSEMBLY

Hide 53878 2.REMOVE FRONT FENDER LINER RH

HINT:

Use the same procedure as for the LH side.

Click hereVehicle Exterior>EXTERIOR PANELS / TRIM>FRONT BUMPER>REMOVAL


Hide 51219 3.REMOVE FRONT SUSPENSION MEMBER LOWER PROTECTOR

Hide 4. DRAIN ENGINE COOLANT (for High Temperature)

Hide 16420 5.REMOVE SUB RADIATOR ASSEMBLY

a.
A433991

Disconnect the coolant lines with the special tool.

SST
09900-WA090  


b.
A442310

Unlock the No. 1 radiator hose and radiator hose sub-assembly (1) and detach them from the sub radiator (2).


c.

Catch and dispose of escaping coolant.


d.
A442340

Loosen T45 bolts (1).


e.
A442341

Guide the sub radiator assembly (1) with the front bumper reinforcement support RH (2) out and remove it.