Hot surfaces.
Risk of burning!
Perform all work only on components that have cooled down.
Life-long fill of coolant!
Do not reuse used coolant.
When replacing and removing components which rely on the corrosion protection effect of the coolant, it is essential to change the coolant. The cooling system must therefore be emptied and refilled.
In the case of other removal work involving the draining of part quantities of coolant, the coolant level must be topped up with new coolant.
Collect and dispose of emerging fluids. Observe country-specific waste disposal regulations.
16420
1.INSTALL SUB RADIATOR ASSEMBLY
Guide in the sub radiator assembly (1) with the auxiliary coolant radiator bracket plate RH (2) and install.
Make sure you can feel the sub radiator supports (3) engage in the body.
Tighten the T45 bolts (1).
Connect the No. 1 radiator hose and radiator hose sub-assembly (1) to the sub radiator (2) and lock.
Make sure that the connections are locked correctly. The locks must engage audibly.
Detach the special tool from the No. 1 radiator hose and radiator hose sub-assembly (1) and guide out.
53878
2.INSTALL FRONT FENDER LINER RH
Use the same procedure as for the LH side.
Click hereVehicle Exterior>EXTERIOR PANELS / TRIM>FRONT BUMPER>INSTALLATION
3.INSTALL WHEEL ASSEMBLY
4.ADD ENGINE COOLANT (for High Temperature)
5.INSPECT FOR COOLANT LEAK (for High Temperature)
51219
6.INSTALL FRONT SUSPENSION MEMBER LOWER PROTECTOR