Home › Engine / Hybrid System › B48 (ENGINE MECHANICAL) › DRIVE BELT
RM3650E _51 Engine / Hybrid System _080178 B48 ENGINE MECHANICAL _0388841 DRIVE BELT G

B48 ENGINE MECHANICAL  DRIVE BELT  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 1.INSPECT FAN AND GENERATOR V BELT

a.

Remove No. 1 engine cover sub-assembly

Click hereEngine / Hybrid System>B48 (ENGINE MECHANICAL)>ENGINE ASSEMBLY>REMOVAL



c.

Inspect fan and generator V belt (first time)

i.
A445542

Release all expanding rivets (1).


ii.

To allow easier access to the wire harness holder, move the cylinder block cover to the side.


iii.
A445543

Using a screwdriver, release the locks of both holders in the marked areas.


iv.

Separate the cable from the holders.


v.

Remove the cylinder block cover.


vi.
A441806

Check the fan and generator V belt (1) for wear, cracks or other signs of damage.


vii.
A445544

Using a screwdriver, remove the holder (1) from the marked area.


viii.

Using a screwdriver, remove the holder (2).


ix.
A441753

Thread in and position the cylinder block cover (2).


x.

Fit all expanding rivets in marked areas.


xi.

Secure clamps (1).



d.

Inspect fan and generator V belt (from second time onward)

i.
A441753

Separate the cable from the holders (1).


ii.

Slide the harness toward the outer side.


iii.

Release all expanding rivets in marked areas.


iv.

Guide out the cylinder block cover (2).


v.
A441806

Check the fan and generator V belt (1) for wear, cracks or other signs of damage.


vi.
A441753

Thread in and position the cylinder block cover (2).


vii.

Fit all expanding rivets in marked areas.


viii.

Secure clamps (1).




f.

Install No. 1 engine cover sub-assembly

Click hereEngine / Hybrid System>B48 (ENGINE MECHANICAL)>ENGINE ASSEMBLY>INSTALLATION