Home › Engine / Hybrid System › B58 (ENGINE MECHANICAL) › TENSION ARM
RM3650E _51 Engine / Hybrid System _080179 B58 ENGINE MECHANICAL _0388900 TENSION ARM A

B58 ENGINE MECHANICAL  TENSION ARM  INSTALLATION  


PROCEDURE

Hide 13800 1.INSPECT INTERMEDIATE LEVER

a.
A441626

Check the intermediate lever classification (arrows).

HINT:
·

All intermediate levers are classified. Only one classification may be used per engine.

All intermediate levers must be installed in the same position in an engine which has already been in use.




Hide 13801 2.INSPECT NO.1 VALVE ROCKER ARM SUB-ASSEMBLY

a.
A441634

Make sure the mounting orientation (arrows) of the No. 1 valve rocker arm sub-assemblies (1) is correct.

HINT:

The No. 1 valve rocker arm sub-assemblies may slip slightly when the camshaft is positioned. Make sure No. 1 valve rocker arm sub-assemblies are correctly positioned on the valve Lash adjuster assemblies and on valves.



Hide 13800 3.INSTALL INTERMEDIATE LEVER

a.
A441624

Guide in and install intermediate lever (1).


b.

Repeat the step for all intermediate levers (1).


Hide 11201 7.INSTALL CYLINDER HEAD COVER SUB-ASSEMBLY