Home › Steering › STEERING COLUMN › STEERING INTERMEDIATE SHAFT
RM3650E _55 Steering _080257 STEERING COLUMN _0389221 STEERING INTERMEDIATE SHAFT A

STEERING COLUMN  STEERING INTERMEDIATE SHAFT  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for LHD and RHD vehicles.

·

The procedure listed below is for the LHD vehicles.



PROCEDURE

Hide 45220 1.INSTALL STEERING INTERMEDIATE SHAFT ASSEMBLY

HINT:
·

The steering intermediate shaft assembly can only be installed in one position.

·

The steering intermediate shaft assembly is encoded for the steering column assembly and the steering gear assembly. The clamping bolt must be positioned in the groove of the steering gear assembly or the steering column assembly.



a.
C406788

Position the steering intermediate shaft assembly (2) at the steering column assembly.


b.

Slide the steering intermediate shaft assembly (2) in the direction of the arrow onto the steering column assembly.


c.

Replace the E10 bolt (1).


d.

Tighten the E10 bolt (1).

Torque:
28 N*m (286 kgf*cm, 21 ft.*lbf)


e.
C406789

Slide the steering intermediate shaft assembly (2) in the direction of the arrow onto the steering gear assembly.


f.

Replace the E10 bolt (1).


g.

Tighten the E10 bolt (1).

Torque:
28 N*m (286 kgf*cm, 21 ft.*lbf)


Hide 51219 2.INSTALL FRONT SUSPENSION MEMBER LOWER PROTECTOR

Hide 3.INSTALL FRONT WHEEL LH (for LHD)

Hide 4.INSTALL FRONT WHEEL RH (for RHD)

Hide 6.INSPECT AIRBAG FOR FUNCTION

Hide 7. START-UP OF ELECTROMECHANICAL STEERING

Hide 8.INSPECT STRAIGHT-AHEAD DRIVING POSITION OF THE STEERING WHEEL