Home › Steering › STEERING COLUMN › STEERING COLUMN ASSEMBLY
RM3650E _55 Steering _080257 STEERING COLUMN _0389216 STEERING COLUMN ASSEMBLY A

STEERING COLUMN  STEERING COLUMN ASSEMBLY  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for LHD and RHD vehicles.

·

The procedure listed below is for the LHD vehicles.



PROCEDURE

Hide 45250 1.INSTALL STEERING COLUMN ASSEMBLY

a.
C413505

Guide steering column assembly (1) into No. 1 steering column hole cover sub-assembly (2) during positioning.


b.
C413504

Replace T45 bolts (2).


c.

Position T45 bolts (2) on the steering column assembly (1).

HINT:

Do not tighten the bolts yet.



d.
C413503

Replace T45 bolts (1).


e.

Position T45 bolts (1) on the steering column assembly at the top.

HINT:

Tightening occurs in the sequence in the next work step.



f.
C417462

The bolts must be tightened in the order (1) to (4).

Torque:
28 N*m (286 kgf*cm, 21 ft.*lbf)


g.
C413502

Clip in the vehicle wiring harness into the bracket (1).


Hide 73900 2.INSTALL LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY

Hide 84310 3.INSTALL TURN SIGNAL SWITCH ASSEMBLY

Hide 45220 4.CONNECT STEERING INTERMEDIATE SHAFT ASSEMBLY

Hide 51219 5.INSTALL FRONT SUSPENSION MEMBER LOWER PROTECTOR (for LHD)

Hide 7.INSPECT AIRBAG FOR FUNCTION

a.

Turn the steering wheel in both directions to the limit position.


b.

The airbag indicator light lights up:

i.

Replace the spiral cable sub-assembly.



Hide 8. START-UP OF ELECTROMECHANICAL STEERING

a.

Connect the diagnosis system to the vehicle and enter the following menus:

Vehicle management / Service functions / Chassis / Electromechanical power steering / EPS: Steering start-up


Hide 9.INSPECT STRAIGHT-AHEAD DRIVING POSITION OF THE STEERING WHEEL

a.

During straight-ahead driving:

i.

Check for correct straight-ahead driving position of the steering wheel.



b.

The steering wheel has an inclination:

i.

Move the steering shaft on the bottom at the steering column.

HINT:

If the steering wheel continues to have an inclination, carry out a toe adjustment at the front axle.