Home › Engine / Hybrid System › B58 (ENGINE MECHANICAL) › ENGINE WIRE HARNESS (for No. 2)
RM3650E _51 Engine / Hybrid System _080179 B58 ENGINE MECHANICAL _0388915 ENGINE WIRE HARNESS(for No. 2) A

B58 ENGINE MECHANICAL  ENGINE WIRE HARNESS(for No. 2)  INSTALLATION  


PROCEDURE

Hide 82122 1.INSTALL NO. 2 ENGINE WIRE

Overview: No. 2 engine wire
A442186

NOTICE:
·

Improper routing of cables and wiring harnesses.

Trapped, crushed or damaged cables may cause short circuits and malfunctions.

-

Route all cables without abrasions, do not trap and crush.




a.
A442187

Thread in and install the No. 2 engine wire.


b.

Secure all clamps.


c.

Connect and lock the connector (1).


d.

Route the connector (2) to the No. 1 integration relay.


e.

Route the connector (3) to the ECM.


f.

Connect and lock the connector (4) for the No. 1 check valve.


g.

Secure clamps (5).


h.
A442188

Connect and lock the connector (1) of the camshaft position sensor (for Exhaust Side).


i.

Connect and lock the connector (2) of the fuel delivery pipe.


j.

Connect and lock the connector (3) on the No. 1 fuel vapor feed hose.


k.

Connect and lock the connector (4) of the servo motor.


l.
A442189

Connect and lock the connector (1) of the fuel pump assembly (for High Pressure).


m.

Connect and lock the connector (2) of the oxygen sensor.


n.

Connect and lock the connector (3) of the wide range air fuel ratio sensor.


o.

Connect and lock the connector (4) of the camshaft position sensor (for Intake Side).


p.

Secure cable channel (5) on the cylinder head cover.


q.
A442190

Connect and lock the connector (1) of the intake mass air flow meter sub-assembly.


r.

Connect the connector (2) of the turbocharger actuator and link assembly and lock it.


s.

Connect and lock the connector (3) of the compressor inlet elbow.


t.
A442191

Connect and lock the connector (1) of the vanos actuator (for Intake Side).


u.

Connect and lock the connector (2) of the vanos actuator (for Exhaust Side).


v.
A442192

Connect and lock the connector (1) of the water pump assembly (for Heater).


Hide 51219 2.INSTALL FRONT SUSPENSION MEMBER LOWER PROTECTOR

Hide 55788A 4.INSTALL COWL TOP VENTILATOR LOUVER PROTECTOR

Hide 51219 5.INSTALL FRONT SUSPENSION MEMBER LOWER PROTECTOR

Hide 12601B 6.INSTALL NO. 1 ENGINE COVER SUB-ASSEMBLY

Hide 17880 7.INSTALL AIR CLEANER HOSE ASSEMBLY

Hide 9.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL