16360A
1.REMOVE FAN WITH MOTOR ASSEMBLY
51410
2.REMOVE NO. 1 ENGINE UNDER COVER ASSEMBLY
53896B
3.REMOVE FRONT FENDER SPLASH FRONT SHIELD LH
53895B
4.REMOVE FRONT FENDER SPLASH FRONT SHIELD RH
Use the same procedure as for the LH side.
5. DRAIN ENGINE COOLANT (for Low Temperature)
16041
6.REMOVE NO. 2 RADIATOR ASSEMBLY
Hot surfaces.
Risk of burning!
Perform all work only on components that have cooled down.
Life-long fill of coolant!
Do not reuse used coolant.
When replacing and removing components which rely on the corrosion protection effect of the coolant, it is essential to change the coolant. The cooling system must therefore be emptied and refilled.
In the case of other removal work involving the draining of part quantities of coolant, the coolant level must be topped up with new coolant.
Collect and dispose of emerging fluids. Observe country-specific waste disposal regulations.
Loosen T30 screws (1).
Unlock the lock (2) and remove the radiator lower air guide plate (3) toward the top.
Unlock and disconnect the No. 5 water by-pass hose (1).
Set No. 5 water by-pass hose (1) aside and secure.
Feed out No. 2 radiator assembly (1) in direction of arrow and remove.