Home › Suspension › REAR SUSPENSION › REAR LOWER ARM (for No. 2 Arm)
RM3650E _53 Suspension _079981 REAR SUSPENSION _0394032 REAR LOWER ARM(for No. 2 Arm) A

REAR SUSPENSION  REAR LOWER ARM(for No. 2 Arm)  REMOVAL  


CAUTION / NOTICE / HINT

CAUTION:
·

Vehicle may slip off the vehicle hoist if the vehicle hoist is handled incorrectly.

Danger! Life-threatening injuries!

-

Observe safety information on raising the vehicle using a vehicle hoist.




HINT:
·

Use the same procedure for the RH side and LH side.

·

The following procedure is for the LH side.



PROCEDURE

Hide 1.REMOVE REAR WHEEL

Hide 48738 2.REMOVE REAR SUSPENSION ARM COVER

Hide 3.REMOVE STONEGUARD

a.
C417127

Loosen the stoneguard (1) at the latch mechanisms (arrows) and remove.


Hide 4.REMOVE REAR COIL SPRING

Hide 48740F 5.REMOVE REAR NO. 2 SUSPENSION ARM ASSEMBLY

a.

for LH Side:

i.
C417112

Unfasten nut (1).


ii.

Remove bracket (2) with the jointed rod.



b.
C415925C01
1.76,1.375 2.177,1.594 true 1.021,1.958 1.563,1.823 true 2.24,1.51 2.479,1.729 0.24,0.219 10 true *a 0.74,1.865 0.979,2.083 0.24,0.219 10 true *b
*a Wooden Block
*b Jack


Support the rear axle carrier sub-assembly with the jack and wooden block.


c.
C417113

Using an 18 mm deep socket wrench, unfasten nut (1).


d.

for Hexagonal Type:

i.

Lift the rear axle carrier sub-assembly with the jack and wooden block to the point where the 18 mm bolt (2) can be removed.


ii.

Pull out 18 mm bolt (2).



e.

for Torx Type:

i.

Lift the rear axle carrier sub-assembly with the jack and wooden block to the point where the E18 bolt (2) can be removed.


ii.

Pull out E18 bolt (2).



f.

Loosen nut (3).


g.

Pull out E20 bolt (4).


h.
C417114

Unfasten nut (1).


i.

Pull out the 18 mm camber adjust bolt (2).


j.

Remove the camber adjust washer (3) and rear No. 2 suspension arm assembly (4).