1. DISCHARGE FUEL SYSTEM PRESSURE
2.REMOVE NO. 1 INTEGRATION RELAY
3.REMOVE ENGINE ROOM ECM BOX
50819
4.REMOVE FRONT FLOOR COVER
77252A
5.REMOVE NO.2 FUEL MAIN TUBE
Working on fuel system.
Risk of fire! Danger of explosion!
When working on the fuel system, make sure that the workbay is sufficiently ventilated, e.g. using extraction unit.
Tightly seal off open lines and connections; collect any escaping fuel directly at the point of exit.
No fire, sparks, open flames or smoking.
On releasing high pressure line, fuel may emerge at high speed.
Danger of injury!
Wear suitable personal protective equipment.
Allow the cooling system to cool down to a temperature below 40°C before starting installation work.
Note warnings on cylinder head cover.
Collect and dispose of emerging fluids. Observe country-specific waste disposal regulations.
UnclipNo.2 fuel main tube (1) from the holders (2).
Unlock snap fastener (3) and pull off No.2 fuel main tube.
Unclip front fuel feed line (1) from the holders (2).
Unlock snap fastener (3) and pull off No.2 fuel main tube (2).
Remove No.2 fuel main tube (1).