Hot surfaces.
Risk of burning!
Perform all work only on components that have cooled down.
85010
1.REMOVE FRONT WIPER MOTOR AND LINK ASSEMBLY
53383
2.REMOVE HOOD TO COWL TOP SEAL
53681
3.REMOVE UPPER FRONT SUSPENSION CENTER BRACE
12601B
4.REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY
55788A
5.REMOVE COWL TOP VENTILATOR LOUVER PROTECTOR
11271A
6.REMOVE REAR CYLINDER BLOCK COVER
50819
7.REMOVE FRONT FLOOR COVER
23827A
8.REMOVE NO. 2 FUEL VAPOR FEED HOSE
Unlock and disconnect snap fastener (1) of the front No. 2 fuel vapor feed hose (2).
Unclip the vehicle wiring harness (1) with the bracket (2) and place aside.
Unlock and disconnect snap fastener (1) of the front No. 2 fuel vapor feed hose (2).
Unclip front No. 2 fuel vapor feed hose (2) from the bracket (3).
Guide out front No. 2 fuel vapor feed hose (2) upwards.