Home › Power Source / Network › B48 (BATTERY / CHARGING) › FRONT POWER DISTRIBUTION BOX
RM3650E _57 Power Source / Network _080072 B48 BATTERY / CHARGING _0395484 FRONT POWER DISTRIBUTION BOX A

B48 BATTERY / CHARGING  FRONT POWER DISTRIBUTION BOX  REMOVAL  


CAUTION / NOTICE / HINT

CAUTION:
·

Working on 12 V vehicle electrical system.

Risk of short circuits! Risk of fire!

-

Disconnect the cable from the negative (-) battery terminal.




PROCEDURE

Hide 1.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

Hide 53681 2.REMOVE UPPER FRONT SUSPENSION CENTER BRACE

Hide 55788A 3.REMOVE COWL TOP VENTILATOR LOUVER PROTECTOR

Hide 4.REMOVE SEALING FRAME

a.
A446513

Loosen T25 screws (1).


b.

Guide out sealing frame (2) upwards.


Hide 5.REMOVE FRONT POWER DISTRIBUTION BOX

a.
A446516

Loosen the cover for the jump start point (1) with the latch mechanisms (2) and remove upwards.


b.
A446517

Loosen the T50 bolt (1) and guide out the No.5 floor wire.


c.

Loosen the nuts (2) and guide out the guide out the generator wire, starter wiring assembly and No. 5 front wire.


d.
A449950

Loosen T45 bolts (1).


e.

Guide out the front power distribution box (2) of the positive battery cable.


f.
A446519

Unlock and disconnect connector (1).


g.
A446520

Lever out the latch mechanisms (1) at the connectors (2).


h.

Pull off the connectors (2).


i.

Remove the front power distribution box of the positive battery cable.