Home › TRANSMISSION ยท A340E AUTOMATIC TRANSMISSION › AUTOMATIC TRANSMISSION SYSTEM

AUTOMATIC TRANSMISSION SYSTEM > HOW TO PROCEED WITH TROUBLESHOOTING

for Preparation Click here


HINT:
  1. The ECM of this system is connected to the CAN and multiplex communication system. Therefore, before starting troubleshooting, make sure that there is no trouble in the CAN and multiplex communication system.
  2. The intelligent tester can be used at steps 3, 4, 6, and 9.



1.Vehicle Brought to Workshop

    NEXT


    2.Customer Problem Analysis

      NEXT


      3.Connect the intelligent tester to DLC3

        NEXT


        4.Check and Clear DTC and Freeze Frame Data (Click here)

          NEXT


          5.Visual Inspection

            NEXT


            6.Setting the Check Mode Diagnosis (Click here)

              NEXT


              7.Problem Symptom Confirmation (Click here)
                Result
                Proceed To
                Symptom does not occur
                A
                Symptom occurs
                B


              B.
              Go to step 9
              A


              8.Symptom Simulation (Click here)

                NEXT


                9.DTC Check (Click here)
                  Result
                  Proceed To
                  DTC is not output
                  A
                  DTC is output
                  B


                B.
                Go to step 17
                A


                10.Basic Inspection (Click here, Click here and Click here)


                  NG.
                  Go to step 19
                  OK


                  11.Mechanical System Test (Click here)


                    NG.
                    Go to step 16
                    OK


                    12.Hydraulic Test (Click here)


                      NG.
                      Go to step 16
                      OK


                      13.Manual Shifting Test (Click here)


                        NG.
                        Go to step 15
                        OK


                        14.Problem Symptoms Table Chapter 1 (Click here)


                          NG.
                          Go to step 18
                          OK


                          15.Problem Symptoms Table Chapter 2 (Click here)

                            NEXT


                            16.Part Inspection

                              NEXT


                              17.DTC Chart (Click here)

                                NEXT


                                18.Circuit Inspection

                                  NEXT


                                  19.Repair or Replace

                                    NEXT


                                    20.Confirmation Test

                                      NEXT

                                      End