Home › ENGINE ยท 2TR-FE › ENGINE MECHANICAL › ENGINE REAR OIL SEAL

ENGINE REAR OIL SEAL > REMOVAL

for Preparation Click here



1. REMOVE MANUAL TRANSMISSION UNIT ASSEMBLY
Transmission
See page
R155
Click here
R155F
Click here


2. REMOVE AUTOMATIC TRANSMISSION ASSEMBLY
(Click here)


3. REMOVE CLUTCH COVER ASSEMBLY (for Manual Transmission)
Transmission
See page
R155
Click here
R155F
Click here


4. REMOVE CLUTCH DISC ASSEMBLY (for Manual Transmission)
Transmission
See page
R155
Click here
R155F
Click here


5. REMOVE FLYWHEEL SUB-ASSEMBLY (for Manual Transmission)


G038108E01
  1. Using SST, hold the crankshaft pulley.

    SST
    09213-54015   (91651-60855)
    09330-00021  



    G035062E03
  1. Remove the 10 bolts, then remove the flywheel.



6. REMOVE DRIVE PLATE and RING GEAR SUB-ASSEMBLY (for Automatic Transmission)


    G038108E01
  1. Using SST, hold the crankshaft pulley.

    SST
    09213-54015   (91651-60855)
    09330-00021  



    A099868E05
  1. Remove the 10 bolts, drive plate spacer rear, drive plate and ring gear and drive plate spacer front.



7. REMOVE ENGINE REAR OIL SEAL


G037552E01
  1. Using a cutter knife, cut off the lip of the oil seal.

  1. Using a screwdriver with its tip wrapped in tape, pry out the oil seal and remove it.

    NOTICE:
    Check the crankshaft for damage after removing the oil seal. If damaged, smooth the surface with 400-grit sandpaper.